Concrete Cutting in Waco, TX
Concrete cutting in Waco, TX takes in saw-cut joints in new slabs, openings and trenches through old ones, and round core holes, with a free estimate from Waco Elite Concrete before any work. Where a new drive meets an existing curb, the City's drive-approach notes require the curb to be sawed.
Call or request a free estimate any time, 24/7
No charge answered 24/7
Get free estimates
Cutting into post-tensioned slabs
Before a blade or core bit goes in, find out whether the slab is post-tensioned. Residential post-tension slabs commonly carry tendons 48 inches on center, and a tendon that gets cut is very hard to repair. One concrete cutting contractor's guide calls for ground-penetrating radar to locate the cables first, and sends any core planned within 6 inches of a marked tendon to a structural engineer.
Cuts in the street, curb or public sidewalk
Every concrete job in Waco's right-of-way takes a right-of-way permit issued by Engineering, which a building permit doesn't cover, and the City gives concrete permits only to contractors bonded with it.
Call or request a free estimate any time, 24/7.
(254) 309-9254How a cutting or coring job runs
What, where and how deep
Tell us what needs cutting, how thick the concrete is, and whether it may hold rebar or post-tension cables.
Locate and lay out
For a repair, the American Concrete Institute sounds out hollow spots, marks simple shapes and keeps the edge cut no deeper than the cover over the steel.
Cut, core and clear
Flat saws take slabs, joints and utility trenches; wall saws, the door, window and mechanical openings; diamond core drills, the round holes.
Call or request a free estimate any time, 24/7.
(254) 309-9254Pieces cut free are broken out and hauled off as concrete removal, and cracked or spalled slabs are covered under repair in Waco.
What concrete cutting costs in Waco
No typical Waco cutting price was found, so the ticket pairs national 2025 figures with the City's fixed fees for cuts that reach a street, curb or public sidewalk. Neither is our price; the estimate is free, like every service we list for Waco.
- Cutting, national (2025)
- $5–$15 per linear ft
- Minimum charge, national (2025)
- $125–$400
- Waco ROW permit
- $55.53 each
- Waco street cut or opening
- $5.32 per sq ft
National averages, 2025; City of Waco fees effective September 1, 2024. Not a quote.
Concrete cutting questions
How much does concrete cutting cost?
National 2025 averages run $5 to $15 per linear foot, with minimum charges of $125 to $400. Breaking out the cut section is a separate cost; typical Waco figures for 2024 put demolition at $1.20 to $1.90 per square foot.
How long does concrete cutting take?
Published guidance times joint cutting in fresh concrete, not whole jobs. The National Ready Mixed Concrete Association puts early-entry dry-cut saws at 1 to 4 hours after finishing and conventional saws within 4 to 12 hours; the Michigan Concrete Association gives a usual window of 8 to 12 hours. Sawing waits if the edges ravel, but left too long it gets difficult and random cracks may form.
How deep can a concrete saw cut?
That depends on the saw, in one cutting contractor's guide. Flat saws reach about 25 inches with the largest blades, though most commercial slab work runs 6 to 12; wall saws about 36 inches from one side; chain saws roughly 15 to 25; wire saws have effectively unlimited depth.
Free estimates for concrete cutting and coring
Pick the cutting or coring option in the form and leave a phone number or email. Requests are answered 24/7.