Concrete Driveways in Bellmead, TX
Concrete driveways in Bellmead, TX get their thickness, edges, joints and mix from what will park on them when Waco Elite Concrete builds one, and every estimate is free.
Call or request a free estimate any time, 24/7
No charge answered 24/7
Get free estimates
Driveway thickness, base and curing
About 67% of Bellmead's housing units, 2,554 of 3,800, are single-family detached houses (Census Bureau, 2020–2024), and a drive for any of them is built around its heaviest vehicle.
The Michigan Concrete Association's guidelines, written for a freeze-thaw climate, call for 4,000 psi concrete at 28 days, 4 inches minimum or 5 with delivery vehicles, and at least 4 inches of compacted sub-base; unstable soil comes out at least 6 inches deep and is refilled with crushed stone, gravel or sand compacted to 95%. They let traffic onto a drive after 7 days of curing, or before that once a test shows 2,500 psi.
Asphalt drives have a service life of about 15 years; a concrete one, properly installed and maintained, should last 30 years or longer. For a patterned surface, see a stamped or colored finish; for the path to the door, the front walk; and for anything else, Bellmead concrete services.
Call or request a free estimate any time, 24/7.
(254) 309-9254Three steps to a new drive
Measure and choose the thickness
Length, width and the heaviest vehicle set the slab, from the 4-inch minimum for cars to more for delivery trucks.
Dig out and build the base
Soft or unstable soil is removed and replaced, the sub-base is compacted, and the forms and steel go in.
Pour, saw and cure
Joints are sawed in the window of about 8 to 12 hours after the pour, and the drive cures before the car goes on it.
Call or request a free estimate any time, 24/7.
(254) 309-9254Driveway prices by thickness
Thickness changes the price: one national estimate for 2025 says adding 2 inches can raise the cost by about 25%. The ticket shows other national 2025 figures. They are averages, not our prices.
- 4-inch driveway
- $6 to $15 / sq ft
- 6-inch driveway, for heavy vehicles
- $8 to $20 / sq ft
- Steel reinforcement, added
- $1 to $3 / sq ft
- Removing an old drive, added
- $2 to $6 / sq ft
National averages, 2025. Averages, not a quote.
Driveway building questions
How thick should the edges of a driveway be?
Thicker than the middle. The edges carry the heaviest loads and have less soil support, so an extra 1 to 2 inches of depth along a band 4 to 8 inches wide at the perimeter helps; one published guide puts the edges at 6 to 8 inches to prevent cracking.
Is there a City fee where a new drive meets a Bellmead street?
Bellmead's Master Fee Schedule lists $50 among its public right-of-way permits for driveway, sidewalk, curb or street construction. The schedule is undated and also carries a residential Concrete Flatwork line, so ask Community Development which one applies before any concrete is broken out.
How wet should driveway concrete be when it arrives?
Stiff enough for a slump of about 4 inches. The Portland Cement Association warns against slumps greater than 5 inches for driveway paving, and a water-cement ratio below 0.50 is advised as well.
Plan a new Bellmead driveway
Select driveway in the form, leave a way to reach you, and expect a free estimate, day or night.