Concrete Driveways in Marlin, TX
Concrete driveways in Marlin, TX are poured with a steady fall toward the street by Waco Elite Concrete for a first drive, an extra car's width beside an old one or a full replacement, and every estimate is free.
Call or request a free estimate any time, 24/7
No charge answered 24/7
Get free estimates
First drives, wider drives and replacements
For a new drive, the Michigan Concrete Association's guideline, written for a freeze-thaw climate, asks for 4,000 psi concrete at 28 days, at least 4 inches thick, 5 where delivery vehicles will use it, on a compacted sub-base of 4 inches or more. The Portland Cement Association warns against a slump over 5 inches.
Widening puts fresh concrete against an old slab, and new concrete can be hard to match in color. Damaged sections alone can be replaced when the trouble is local, but sinking, poor drainage, heavy spalling and significant cracking all point to replacing the whole drive.
A patterned finish is covered under stamped concrete; if one panel has dropped and the rest are sound, ask about lifting it in Marlin, and see the full list of Marlin services for everything else.
Call or request a free estimate any time, 24/7.
(254) 309-9254Grade, pour, then keep off
Grade and base
Soft spots are dug out and refilled, the sub-base compacted, and forms set to give the slab its fall toward the street.
Pour and cut joints
On a 4-inch drive, joints go no more than 10 feet apart and a quarter of the depth, 1 inch, with an isolation joint where the drive meets a walk or garage slab.
Wait before driving
Feet can go on after 48 hours and a car after 7 to 10 days, kept off the edges; after 30 days the drive takes all normal traffic.
Call or request a free estimate any time, 24/7.
(254) 309-9254Highway bids and home driveway prices
The ticket pairs two sorts of figure: average low bids for driveway items on state jobs in the district run from Waco, which covers Falls County, and national 2026 figures for a home drive. A square yard is 9 square feet, and highway bids are large contracts, not home prices. None is our price.
- Highway bid, driveway (1,361 sq yd)
- $58.00 / sq yd
- Highway bid, high-early-strength (368 sq yd)
- $73.00 / sq yd
- Plain home drive, national
- $5 to $8 / sq ft
- Tear-out, national
- about $1.00 / sq ft
Highway bids from a table dated December 31, 2016; national figures for 2026. Not a quote.
Asked about drives in Marlin
How wide should the joint be between an old drive and a new strip beside it?
The American Concrete Pavement Association uses an isolation joint where old pavement meets new: ½ to 1 inch across, running the full depth and packed with a pre-formed filler, so each slab moves on its own.
How is a drive on flat ground made to drain toward the street?
The fall is formed into the slab. By the Texas State Historical Association's description, Falls County's terrain is gently rolling with broad flatlands, so the slope has to be built into the drive: at least ⅛ inch per foot toward the street and away from the house and garage, as the Portland Cement Association recommends.
Does skipping the cure really weaken a driveway?
It can. In extreme cases, failing to cure right after final finishing can cut strength by up to 50%, so curing should start once finishing is done and normally run 3 to 7 days.
A free price on your drive
Pick driveway on the form and leave a phone number or email. Requests are answered 24/7, and the estimate costs nothing.