Concrete Sidewalks in Robinson, TX
Concrete sidewalks in Robinson, TX are built by Waco Elite Concrete for homeowners, landlords, schools, churches and businesses, from a front walk to the door to a path across a property, with a free estimate first.
Call or request a free estimate any time, 24/7
No charge answered 24/7
Get free estimates
Walks for homes, schools and public places
The Texas State Historical Association lists a high school, a junior high and three elementary schools in Robinson ISD in 1990, and the City's Peplow Park counts a walking and jogging trail among its pavilion, playgrounds, sand volleyball and basketball court.
Walks at stores, offices and government buildings fall under the 2010 ADA Standards, though the residence-only part of a private home is not covered. Public sidewalks are usually coded at 4 inches, with 2 inches added where they cross a driveway, an Ohio industry recommendation notes.
For work in the street right-of-way, Robinson's fee ordinance of March 18, 2025 (No. 2025-005) sets right-of-way permit fees of $100 with no excavation, trenching or locating, $150 otherwise, and $250 when a temporary, full or partial street closure is needed. Sidewalks don't appear on the City's permit page, so ask the Permits and Inspections Department which permit a new walk needs.
Where a walk meets the drive, see Robinson driveways; a cracked old walk belongs with crack repair in Robinson, and the Robinson service list has the rest.
Call or request a free estimate any time, 24/7.
(254) 309-9254Laying out and pouring a walk
Route and width
Set the path, its width and how it drains away from the house.
Base and forms
The ground is dug out, a compacted base goes down, and forms are set to the planned thickness.
Pour, cure and open
Michigan's concrete association lets a walk or drive take traffic after 7 days of curing, or earlier if tests confirm 2,500 psi.
Call or request a free estimate any time, 24/7.
(254) 309-9254What a new walk costs
Nationally in 2026, a 4-inch walkway ran $6 a square foot and sidewalks 4 to 6 inches thick $6 to $9. An older national figure, from 2020, puts most walkways at $6 to $12 a square foot, or $840 to $1,680 for a 140-square-foot walk. These are averages, not our prices.
Sidewalk questions for Robinson properties
When does a step in a walkway have to become a ramp?
The 2010 ADA Standards allow a vertical step of up to ¼ inch. Between ¼ and ½ inch the edge must be beveled no steeper than 1:2, and past ½ inch the change counts as a ramp, which may rise no more than 30 inches per run at a slope no steeper than 1:12 and must be at least 36 inches wide.
Which TxDOT concrete class covers sidewalks?
Class A. No Robinson sidewalk specification was found, but on state work TxDOT lists sidewalks, driveways and curb and gutter among Class A's general uses and gives it at least 3,000 psi design strength and a water-cementitious ratio no higher than 0.60.
What hours does Robinson run its building inspections?
The Permits and Inspections Department at 111 W Lyndale schedules inspections on weekdays between 8:00 a.m. and 4:00 p.m., and its office is open weekdays from 8:00 a.m. until 5:00 p.m.
Walkway estimates for Robinson properties
Choose sidewalk or walkway, leave a number or an email, and a free estimate comes back; requests are answered 24/7.