Concrete Leveling in Oglesby, TX
Concrete leveling in Oglesby, TX keeps the old slab: Waco Elite Concrete bores a few ports through a settled walk, porch slab, step or drive panel, fills the gap beneath with grout or foam until it comes back up, and patches the ports, all after a free estimate.
Call or request a free estimate any time, 24/7
No charge answered 24/7
Get free estimates
Lifting walks, steps and porch slabs on older lots
Oglesby's housing has a median year built of about 1972, by Census Bureau survey estimates for 2020–2024 that carry a wide margin of error, and under the town's Census centre point the federal soil database lists two clay-rich layers above bedrock. Leveling is for the walks, steps and panels that have settled on it.
Lifting suits a slab that has dropped and is still sound. One that was pushed up by swelling soil, one whose surface is spalling, or one whose cause of settling hasn't been dealt with is not a mudjacking job, according to a home-inspector association's list.
Two fills are used. The grout used for slabjacking starts with portland cement and water, then adds limestone dust, fly ash or sand, along with additives. Foam is the light option, typically 2 to 4 pounds a cubic foot of polyurethane next to as much as 100 for mudjacking material; it gains 90% of its strength in about 15 minutes and resists water, which one foam maker says helps prevent future erosion and settling.
A house or garage slab gets one more check, for post-tension tendons, before any port is drilled.
Cracks and chipped edges go under concrete repair in Oglesby, and a walk that lifting can't save under new sidewalks; the full list is on our Oglesby page.
Call or request a free estimate any time, 24/7.
(254) 309-9254Check, lift, patch
Check the slab and the cause
The drop is measured, the surface checked for spalling, the cause looked for, and any tendons in a house slab located.
Bore and fill
Small ports are bored, and the fill is pumped in below until the panel is back in line.
Plug the ports, reopen
The ports are filled, and the slab reopens once its fill has cured, which takes far less time with foam than with grout.
Call or request a free estimate any time, 24/7.
(254) 309-9254Slab leveling prices by job
A new slab usually costs more: national 2025 figures put it at 50% to 70% above the price of leveling, with mudjacking at $5 to $25 a square foot and foam at around $20 to $25. Averages only, not our prices.
- Steps
- $1,335 to $3,240
- Sidewalk
- $1,015 to $3,240
- Patio
- $1,215 to $4,725
- Driveway
- $1,215 to $5,670
National figures, 2026. Not a quote.
Leveling questions from Oglesby
Is it safe to drill a post-tensioned garage floor for leveling?
Only with care. A cut tendon is very hard to repair, so a post-tensioned slab should never be drilled casually. One cutting contractor's guide calls for ground-penetrating radar scanning before cutting or coring, and for a structural engineer's review of any core within 6 inches of a marked tendon.
Does stone slurry grout cost less than foam?
In one national leveling company's 2026 price list, yes: a driveway runs $900 to $4,200 with stone slurry grout, against $1,215 to $5,670 with foam and $810 to $3,780 with mudjacking.
Does the clay in Oglesby swell more near the surface or deeper down?
Near the surface, at the town's Census centre point. The soil database puts the top layer, roughly the first 6 inches, at 47.5 percent clay and gives it a linear extensibility (the database's shrink-swell measure) of 7.2 percent; the layer below is 45 percent clay at 4.1 percent, and bedrock starts about 14 inches down.
Have a settled slab measured
Choose concrete leveling on the form and add a phone number or email. The estimate costs nothing, and requests are answered 24/7.