Concrete Resurfacing in Riesel, TX
Concrete resurfacing in Riesel, TX, on the eastern side of McLennan County, where the Texas State Historical Association finds black, waxy clay and sand loam soils, is offered by Waco Elite Concrete for slabs that have stopped moving, with a thin overlay or a fresh sealer and a free estimate.
Call or request a free estimate any time, 24/7
No charge answered 24/7
Get free estimates
Clay first, overlay second
A slab whose cracks run deep and wide, or keep growing, especially with one edge raised, may be settling on unstable ground, which no surface layer fixes, one published guide warns. Another says never to put a new surface on a driveway with severe cracking or damage.
On a stable slab, one maker's professional fine overlay is laid between 1/16 and 3/16 inch, tests at 5,860 psi after 21 days and goes down only between 45°F and 85°F, air and slab alike. Another maker's spray-down deck coating, meant for pool decks, walks and patios, stays at 1/4 inch or thinner, dries a day or more before sealing and can take a grip additive in the sealer.
For sealing on its own, one published guide says a high-quality sealer applied every few years can benefit all types of flatwork by blocking moisture.
Cracks that need filling first come under crack repair before resurfacing, a patterned top under a stamped overlay in Riesel, and all Riesel services are on the town page.
Call or request a free estimate any time, 24/7.
(254) 309-9254Renewing a stable slab
Check for movement
Cracks are measured and checked for one side sitting higher; a slab that is still moving is repaired or replaced first.
Profile and keep the joints
The surface is cleaned and roughened, and each control joint is marked to carry up through the new layer.
Thin layer, then sealer
The overlay goes on within its maker's thickness and temperature range, and sealer follows in thin coats.
Call or request a free estimate any time, 24/7.
(254) 309-9254Sealer prices by type
Nationally, cleaning and sealing concrete runs $1 to $3 per square foot, or $250 to $600 for a 10-by-20-foot patio, with minimum service fees of $150 to $300 (2025). These are averages, not our prices.
- Acrylic
- $1.00–$2.00 / sq ft
- Penetrating (siloxane or silicate)
- $1.00–$3.00 / sq ft
- Polyurethane
- $1.25–$3.00 / sq ft
- Pressure washing
- $0.35–$0.75 / sq ft
National averages, 2025. Not a quote.
Riesel resurfacing questions
Can an overlay go on a slab that is still moving?
Not for long. Over concrete that is damaged, cracked or moving with the ground, an overlay soon fails, one published guide says, and it names low-grade resurfacing materials, inadequate prep work and errors in mixing or applying as the usual culprits when one fails early.
Is sand a good grip additive for concrete sealer?
No. The American Society of Concrete Contractors warns that sand and some silica materials can actually wear a sealer down. Its guide points to purpose-made anti-skid additives instead, enough on a public walkway outdoors that a bare hand can feel them, in a sealer that meets ASTM 2047 for slip resistance.
Is resurfacing cheaper than pouring new concrete?
Yes, if the slab underneath is sound: on national pool deck figures (2026), a new pour costs $6 to $10 a square foot and resurfacing starts at $3 to $5.
Resurface or reseal in Riesel, priced free
Pick resurfacing or sealing in the form and leave a phone number or email. The estimate is free, and requests are answered 24/7.